Linux lhjmq-records 5.15.0-118-generic #128-Ubuntu SMP Fri Jul 5 09:28:59 UTC 2024 x86_64
Your IP : 18.222.98.91
# SPDX-License-Identifier: GPL-2.0-only
#
# Exar device configuration
#
config NET_VENDOR_NETERION
bool "Neterion (Exar) devices"
default y
depends on PCI
help
If you have a network (Ethernet) card belonging to this class, say Y.
Note that the answer to this question doesn't directly affect the
kernel: saying N will just cause the configurator to skip all
the questions about Neterion/Exar cards. If you say Y, you will be
asked for your specific card in the following questions.
if NET_VENDOR_NETERION
config S2IO
tristate "Neterion (Exar) Xframe 10Gb Ethernet Adapter"
depends on PCI
help
This driver supports Exar Corp's Xframe Series 10Gb Ethernet Adapters.
These were originally released from S2IO, which renamed itself
Neterion. So, the adapters might be labeled as either one, depending
on its age.
More specific information on configuring the driver is in
<file:Documentation/networking/device_drivers/ethernet/neterion/s2io.rst>.
To compile this driver as a module, choose M here. The module
will be called s2io.
config VXGE
tristate "Neterion (Exar) X3100 Series 10GbE PCIe Server Adapter"
depends on PCI
help
This driver supports Exar Corp's X3100 Series 10 GbE PCIe
I/O Virtualized Server Adapter. These were originally released from
Neterion, which was later acquired by Exar. So, the adapters might be
labeled as either one, depending on its age.
More specific information on configuring the driver is in
<file:Documentation/networking/device_drivers/ethernet/neterion/vxge.rst>.
To compile this driver as a module, choose M here. The module
will be called vxge.
config VXGE_DEBUG_TRACE_ALL
bool "Enabling All Debug trace statements in driver"
default n
depends on VXGE
help
Say Y here if you want to enabling all the debug trace statements in
the vxge driver. By default only few debug trace statements are
enabled.
endif # NET_VENDOR_NETERION
|